Universal Laser Systems CLP-100NI-NPRT Instrukcja Użytkownika Pobierz pdf (Strona 37)

MAINTENANCE

INKING SYSTEM ASSEMBLY

The following steps will guide you through the Ink Roll Eccentric Assembly.

1 - Install the O-Ring in the groove of the Eccentric flange,

then install one of the white delrin washers on the Eccen-

tric.

FIGURE 74

FIGURE 75

FIGURE 76

FIGURE 77

2 - Apply a thin coating of grease to the O-Ring and the Ec-

centric to approximately 1/2” from the flange.

3 - Insert the Eccentric into the Inking System Cover. Rotate

and pull the Eccentric from the opposite side until the o-

ring slips into the bore. When fully seated, the flange of

the eccentric will be approximately 0.010” above the sur-

face of the cover. Rotate the Eccentric and align the dimple

on the Eccentric flange with the dimple in the cover.

4 - Install the second white delrin washer over the Eccentric.

Automotive wheel bearing grease is recommended.

ECCENTRIC O-RING

ALIGN DIMPLES

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 43 44 45

Brak uwag

Universal Laser Systems CLP-100NI-NPRT Instrukcja Użytkownika Strona 37