Universal Laser Systems Laser Platform M-300 Instrukcja Naprawy Pobierz pdf (Strona 60)

Maintenance 6-7

Battery Replacement

WARNING: There is a danger of explosion if the battery is incorrectly replaced.

Replace the battery only with the same or equivalent type recommended by the

battery manufacturer. Using an incorrect battery, recharging or disassembling the

battery may present a danger due to fire or explosion. Dispose of used batteries

promptly according to the local regulations.

Cooling Fan Filters

This air-cooled laser system will require periodic

cleaning of the cooling fan filters. Since ambient air

is used to cool the laser tube, the air must be filtered

before it enters the inside of the laser system

otherwise dirt and dust can build up inside of the

laser system and damage it. The contaminants

reduce the laser system’s cooling ability and will

cause the laser tube to overheat. An overheated

tube will lose laser power during engraving and will

eventually shut down completely. The laser tube

has a built in safety mechanism that will shut the

beam off before it can damage itself.

The cooling fan filters are located on the back of the

laser system. To service the filters, first unplug the

laser system. Unlatch the rear laser cover and lift it

open. The filters are located where the arrows are

pointing in the illustration. To remove the filter(s),

simply snap off the black cover and remove the foam

element. Wash the element in a soap and water

solution, dry, and re-install.

NEVER OPERATE THE LASER SYSTEM WITH THE COOLING FAN FILTERS

REMOVED. This can permanently damage the laser system. Damage from this

kind of abuse WILL NOT be covered under warranty.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 99 100

Brak uwag

Universal Laser Systems Laser Platform M-300 Instrukcja Naprawy Strona 60